Home Theater

What do you need to think about when you’re building a basement home theater First, how big will this room be Determine the number of people you anticipate having over for movies most of the time.

Sunday football destination – Home Theater

If this is about to become the Sunday football destination, you want everyone to be comfortable. Unlike a traditional residential installation, the electronic gear takes center stage in this retrofit. The equipment rack is the theater’s focal point and each piece – including McIntosh amplifiers and controller and Richard Gray power conditioner – emit a captivating blue light, creating a spectacular effect. The room also is acoustically treated with a beautiful gold and maroon motif and the ceiling in black. While the rack is on display, a Crescendo-constructed stage hides the front speakers and the sound attenuating wall treatment conceals the in-wall surrounds.

A high-definition sound system can create an amazing audio experience. However, you need to take into consideration the noise control regulations laid down by your local government before wiring the sound system. A typical home theater consists of a 5.1 surround sound system. You can opt for a more sophisticated system such as a 7.1 surround sound if the local regulations permit. Here are a few things that you need to keep in mind when arranging the speakers.

If you are using a 5.1 surround sound system, place the three speakers and the woofer towards the front of the room. The remaining two speakers should be placed slightly behind your home theater seating.
If you are using a 7.1 system, the 6th and 7th speakers should be placed right behind the audience. The rest of the arrangement remains the same as that of a 5.1 system.

If possible, avoid square rooms and long narrow rectangular rooms because deep bass sound waves misbehave or “pile up” in square or extra-long rooms. They produce “standing waves,” which result in areas with bass peaks where you’ll hear way too much bass, and “nulls,” where you’ll hear virtually no deep bass. Sometimes these areas of too much or too little bass will vary every one or two feet.

Trying to fix the standing-wave problem after the fact using electronic band-aids like Equalization or an AV receiver’s auto-EQ program is virtually impossible.

Instead, select a rectangular shaped room where the dimensions (length, width and height) are not evenly divisible by a common denominator. For example, don’t choose a room 24 x 16 x 8 ft.; instead lay out dimensions of 23 x 13 x 7 feet. That way, you’ll minimize standing waves.

Turning your attic space into a movie room comes with several challenges. So, you may have to do the following:

You may need to create extra storage space in the garage or someplace else as the spare room will be cleared of items such as dressers, shelves, beds, chairs, and cupboards. The electronic equipment and the seats in a media room will occupy most of the space. So, make sure to remove as many items as possible.
More often than not, people use their garage as extra storage space. Move out the stored items to a separate storage facility in your house. You may have to rent a storage space, if necessary.
Wiring is a major concern because you will need custom wiring for electronics and lighting in the room. Due to the limited space, laying down concealed wiring can be a challenge.
Choosing the right seats for a home theater can be a challenge too because of the limited seating area.
Installing the right type of home theater equipment, including a display screen and a projector can be tricky especially if the room is too small. This applies to home theater seating as well.
Getting furniture and certain other large items into the attic via narrow staircases could be a potiential issue.

Be the first to comment

Leave a Reply

Your email address will not be published.